Spray foam insulation
Spray foam fills odd framing and seals air as it goes, which helps in additions and the room over the garage where batts never fit right. It's the pricier choice, so we use it where it's worth it.
Insulation contractor in El Monte, CA - attics sealed and filled for inland heat
B&J Pico Rivera Insulation Company insulates and air seals attics, walls and crawl spaces in El Monte homes, and we clear out old insulation first when it's been soaked or filled with droppings.
What we find in El Monte attics
El Monte is inland, in what the state calls climate zone 9, and summer heat is behind most of the calls we get here: a hot back bedroom, an AC that runs all afternoon, a power bill that climbs every July. A lot of the houses are older single-story homes with the ductwork in the attic, and plenty are rentals where nobody has looked past the hatch in years. We're based in Pico Rivera, a short drive south, and we do the same work east of here in West Covina.
The price moves with how many inches are already up there and what shape they're in, how many gaps need sealing, whether old material has to come out first, and whether foam makes sense for your house. The schedule mostly turns on removal and on whether your job needs a permit, and since addresses near the city line can fall under the county instead, we check which building office covers yours before we start. You can check too, because the city's permit applications page has a link that tells you whether your address is inside the city. Your own figure comes in the written estimate, along with photos of what I found.
Photos before a price
I go up into the attic and under the house, take photos and walk you through them, so you understand what you're paying for and can spot a bad bid later.
Leaks and wiring come first
If I find a roof leak or old wiring, I'll tell you to fix that before we insulate, because new insulation over a wet spot or a bad splice just hides it.
Foam when the ducts live up there
Sealing the gaps and topping up loose fill is usually the better buy, but when your ductwork runs through a hot attic, foam under the roof keeps those ducts out of the worst heat.
Insulation work we do in El Monte homes
Attic insulation
Most calls here start with a hot house and a thin layer in the attic. We measure how many inches you already have, seal the gaps, then bring it up evenly, edges included, not just the middle.
Blown-in insulation
Blown-in fill, loose material blown through a hose, is the usual way to top up an older attic. We keep it even out to the eaves and keep it off the vents so the attic can still breathe.
Home insulation
When a house feels drafty or uneven from room to room, I look at the attic, walls and floors together, because heat moves through whichever part is weakest. Then we fix the worst spots first.
Insulation removal
We vacuum old insulation out into bags, clean up droppings and debris, and haul it away, so the attic is clean before anything new goes in. Landlords often call us for this between tenants.
Crawl space insulation
Houses with a raised floor can have cold floors in winter and damp underneath. We check the crawl space for moisture and pests first, then insulate under the floor so it stays up and stays dry.
Wall insulation
Many older houses here have walls that are empty or have insulation that's slumped, and you feel it on the sunny side. We fill closed walls through small holes and patch them, or insulate open walls during a remodel.
Air sealing services
Air sealing, closing the gaps before insulating, covers the whole house, from can lights and wiring holes to plumbing under sinks and the floor over the crawl space. Skip it and the insulation ends up fighting a draft.
Basement insulation
Basements are uncommon in El Monte, but when a house has one or a cellar under an addition, we insulate the walls with material that handles damp, so it doesn't hold moisture against the wood.
Closed-cell foam insulation
Closed-cell foam, a dense foam that also blocks moisture, fits damp spots like a crawl space wall, or tight spaces where there's little room for thickness. We use it where those two things matter most.
Open-cell foam insulation
Open-cell foam is softer and lighter, and it's a common pick for the underside of the roof when the ductwork lives in the attic. It quiets noise too, though it doesn't stop moisture like closed-cell does.
Commercial insulation
We also insulate small shops, offices and rental buildings, working around tenants and business hours. Property managers call us because we'd rather show them a problem than cover it up and leave it for later.
Crawl space vapor barrier
A heavy plastic liner over the dirt under the house keeps ground moisture away from the floor and the insulation above it. We overlap and seal the seams and run it up the walls so it stays put.
Vapor barrier installation
Where moisture can collect in a wall, floor or crawl space, a vapor barrier keeps it out of the insulation. We put it on the right side for that space, because the wrong side can trap damp in the framing.
Attic air sealing
Before topping up an attic, we seal the tops of the walls, the pipe and wire holes and the hatch. That's where hot attic air slips into your rooms, and it's easiest to reach before new insulation covers it.
Retrofit insulation
Retrofit work means adding insulation to a house that's already built and lived in. In older homes I check the roof and wiring first, because I'd rather you fix those than have us bury them.
Get a free on-site insulation estimate in El Monte
Send the form and we'll get back to you within one business day. I come out, look at the attic and whatever's bothering you, and give you a written estimate with photos, free and with no obligation.
Tell us what you're noticing
A hot back bedroom, a high power bill or cold floors each point me somewhere different, so a line about it in the form helps me look in the right place first.
Clear a path to the hatch
Attic hatches are often in a closet or the garage, and I need to get up there and under the house to see what's really going on before I write anything.
I check the finished work
Our installers do the work, and I go over it with you before we call it done. We're fully licensed and insured, and satisfaction guaranteed.
Insulation questions from El Monte homeowners
Here's what El Monte homeowners usually ask before we head up into the attic, from permits to whether you'll need to leave.
Who handles building permits for insulation work in El Monte?
For projects inside the city, El Monte's Building Department is the main contact for plan review, permits and inspections, and its counter staff tell you which other city departments your project involves. The counter is open without an appointment, applications go in in person, and anything filed now goes under the current California building code. If your job needs a permit, we handle the paperwork and inspections.
Can you put new insulation over the old insulation in my attic?
Yes, if the old layer is dry and clean and just too thin, we seal the gaps and top it up. If it's been soaked by a roof leak or is full of droppings, it comes out first, because fresh material on top keeps the damp and the smell right where they are. My photos will show you which one you've got.
Do we have to leave the house while you insulate?
Usually not for blown-in fill or air sealing, since the work happens in the attic and you can stay home while we keep the hatch area closed off. Spray foam is different, because it comes with a re-entry time, the wait before people and pets can come back inside, set by the foam maker. We tell you that wait ahead of time so you can plan.
Cities where we do insulation work
These are the cities with their own page on our site, not the only places we work. If yours isn't listed, call or send the form and we'll tell you whether we cover it.
Get your El Monte attic looked at
Call (562) 271-1051 any day between 7 AM and 11 PM, or send the form, and we'll set a time that fits your week.